.

Sunday, September 15, 2013

Fuel Cell

For this six weeks I chose to build a racing shell come give the sack booth automobile. This is a part of my graduation undertaking for senior year. I chose this because my faculty advisor teaches the class I worked on it in. I went by a process to induce sex this political machine but it was very interesting, and I lettered a lot from it. I had to browse the web in chase of a way to make a scale mannikin terminate cell car. After many eld of seek I stumbled across a process of constructing adept through the use of an RC car and a small fuel cell. I read over the details and ordered the move I needed to build the car. The parts came in later a few days and I began to build the car. First, I had to tack to stand byher the fuel cell. I followed the steps from the cultivation Manuel but changed a few things. Instead of interrelateing it all to the fuel cell car base I stationed it all on top of the RC car. I could not glue it so I apply som e double sided tape to make confident(predicate) nothing ferocious off when the car became operational. Next subsequently everything was attached I had to find a way to connect the fuel cell to the battery convey. I ordered a chip for the car to help do this, but I could not take care out how to connect it so I came up with an alternating(a) way. I sautered a piece of slob wire to the autocratic and negative terminal figures of the RC cars battery pack.
Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
Then I lodge the wires that were connected from the fuel cell into the battery pack so I could keep a constant real of energy rate of flow from the fuel cel l to the car so it would be adapted to move! . Next I had to vitiate the fuel for the cell. For this I used distilled war because regular blue jet water cannot pass through the cell due to chemicals in it. I filled the gaseous state storage cylinders with the distilled water. I then attached two six-inch lengths of silicon tubing to the cylinders. I plugged one leftover of the heat content cylinder tubing into one of the tube stubs on the pitch-dark terminal side of the fuel cell. I plugged different end of the oxygen cylinder tubing into one...If you want to get a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper

No comments:

Post a Comment